Notes Switch travel diagram
  Contact closed
  Contact open
  Setting range
  Break point
  Positive opening sequence/- angle
VS  adjustable range of NO contact
  adjustable range of NC contact
N   after travel
Deutsch  English  Francais  Nederlands  Italiano  Español  Português  Suomi  Svenska  Norsk  Dansk  Polska  日本語  Türkiye  中文  Português-br  
  
• Solenoid interlock
• Integrated AS-Interface
• Thermoplastic enclosure
• 90 mm x 84 mm x 30 mm
• Double-insulated
• High holding force
• Actuator monitored

 
Preferred typ
 
Ordering details
 
Product type descriptionAZM 170 B ST-AS RP
Article number101210927
EAN Code4030661390413
eCl@ss27-27-26-03
 
Approval
 
Approval AS-i
TÜV
USA/CAN
 
Classification
 
StandardsEN ISO 13849-1, IEC 61508
PLup c
Control category1
PFH1.16 x 10-6 / h
- noticeup to max. 100.000 switching cycles/year
SILup 1
Mission time20 Years
If a fault exclusion for hazardous damage of the 1-channel mechanics is authorized and an adequate protection against tampering is ensured, suitable for use up to:
StandardsEN ISO 13849-1, IEC 61508
PLup d
Control category3
PFH value1.01 x 10-7 / h
- noticeup to max. 100.000 switching cycles/year
SILup 2
Mission time20 Years
 
Global Properties
 
Permanent lightAZM 170 AS
StandardsEN 50295, EN 60947-5-1, IEC 61508, EN ISO 13849-1
Compliance with the Directives (Y/N) Yes
Number of actuating directions2
Active principleelectromechanical
Duty cycle EDMagnet 100 %
Materials
- Material of the housingsglass-fibre reinforced thermoplastic, Plastic self-extinguishing,
Housing coatingNone
Weight310
Guard locking monitored (Y/N)No
Actuator monitored (Y/N)Yes
Response time< 100
 
Mechanical data
 
Design of electrical connectionconnector plug M12, 4-pole
Mechanical life> 1.000.000 operations
Manual release (Y/N)No
Latching force30
Clamping force F1000 N
Max. Actuating speed2
 
Ambient conditions
 
Ambient temperature
- Min. environmental temperature−25
- Max. environmental temperature+55
Storage and transport temperature
- Min. Storage and transport temperature−25
- Max. Storage and transport temperature+85
Relative humidity30 … 95
- non-condensing
- non-icing
Protection classIP67 to IEC/EN 60529
Protection ratingII
Air clearances and creepage distances To IEC/EN 60664-1
- Rated impulse withstand voltage Uimp0,8 kV
- Rated insulation voltage Ui32 VDC
- Overvoltage categoryIII
- Degree of pollution3
 
Electrical data
 
Power to unlockYes
Power to lockNo
 
Electrical data - AS interface
 
AS-i Supply voltage26.5 … 31.6 VDC, Protection against polarity reversal
AS-i operating current≤ 50
AS-i Device insulationinternally short-circuit proof
AS-i Specification
- versionV 2.1
- ProfileS-7.B.F.E
- IO-Code0x7
- ID-Code0xB
- ID-Code10xF
- ID-Code20xE
AS-i Inputs
- Channel 1Data bits DI 0/DI 1= dynamic code transmission
- Channel 2Data bits DI 2/DI 3= dynamic code transmission
AS-i Outputs
- DO 0Solenoid control
- DO 1not used
- DO 2not used
- DO 3not used
AS-i Parameter bits
- P0Safety guard and actuator detected
- P1Solenoid interlock locked
- P2not used
- P3not used
AS-i input module address0
- Default on address 0, programmable via the AS-Interface Master or Hand-held programming device
 
Electrical data - Auxiliary voltage (Aux)
 
Supply voltage UB24 VDC (−15 % / +10 %) stabilised PELV
Operating current≤ 500
Device insulation≤ 4 A (if used in accordance with UL 508)
 
LED switching conditions display
 
LED switching conditions display (Y/N)Yes
AS-i LED switching conditions display
(1) green LEDSupply voltage
(2) red LEDCommunication error / slave address = 0
(3) yellow LEDEnabling status
 
ATEX
 
Explosion protection categories for gasesNone
Explosion protected category for dustsNone
 
Dimensions
 
Dimensions of the sensor
- Width of sensor90
- Height of sensor75.5
- Length of sensor30
 
Pin assignment
 
1AS-i +
2Aux − (P)
3AS-i −
4Aux + (P)
 
notice
 
Interlocks with power to lock principle may only be used in special cases after a thorough evaluation of the accident risk, since the guarding device can immediately be opened on failure of the electrical power supply or when the main switch is opened.
 
Included in delivery
 
Actuators must be ordered separately.

K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal
The data and values have been checked throroughly. Technical modifications and errors excepted.
Generiert am 23.05.2019 - 11:54:35h Kasbase 3.3.0.F.64I