• Thermoplastic enclosure • Small body • Concealed mounting possible • 26 mm x 36 mm x 13 mm • Long life • no mechanical wear • Insensitive to transverse misalignment • Insensitive to soiling • Connector 8 mm, 6-pole, Latching interlocking
Axial misalignment The safety sensor and the actuator tolerate a horizontal and vertical misalignment to each other. The possible misalignment depends on the distance of the active surfaces of the sensor and the actuator. The sensor is active in the tolerance range.
Type of actuation
Direction of motion
head-on with regard to the active surface
restistance to shock
30 g / 11 ms
Resistance to vibration
10 … 55 HZ, Amplitude 1 mm
- Min. environmental temperature
- Max. environmental temperature
Storage and transport temperature
- Min. Storage and transport temperature
- Max. Storage and transport temperature
Integrated Safety monitoring module available (Y/N)
Cross circuit/short circuit recognition possible (Y/N)
max. 5 HZ
max. 24 VDC
max. 10 mA
max. 240 mW
Design of control output
Number of shutters
Number of openers
Design of output signal switching device
Electrical data - Safety outputs
Number of secure semi-conductor outputs
Number of secure outputs with contact
Electrical data - Diagnostic output
Number of semi-conductor outputs with signaling function
Number of outputs with signaling function that already have a contact
LED switching conditions display
LED switching conditions display (Y/N)
- The LED is illuminated when the guard is closed.
Explosion protection categories for gases
Explosion protected category for dusts
Dimensions of the sensor
- Width of sensor
- Height of sensor
- Length of sensor
Contact symbols shown for the closed condition of the guard device.
The contact configuration for versions with or without LED is identical.
The number in brackets indicate the PIN number of the connector.
Contact S21-S22 und S11-S12 must be integrated in the safety circuit
Included in delivery
Actuators must be ordered separately.
Note Diagram positive break NC contact active no active Normally-open contact Normally-closed contact
K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal The data and values have been checked throroughly. Technical modifications and errors excepted. Generiert am
08:24:02h Kasbase 3.3.0.F.64I