A safety edge system consists of individual components. The components must be ordered separately.
Example: Rubber profile, SE-P40-1250 Al profile, SE-AL 10-1250 Emitter/ Receiver SE-SET Safety-monitoring module, SE-304 C
Options: Caps SE-T40; Sticker SE-G8406 Other accessories
EN ISO 13850
Compliance with the Directives (Y/N)
- Material of the rubber profile
Coated profile (Y/N)
max. permanent load
500 on the operational switching zone
max. 9 mm
max. 18 mm
The protection class IP 67 applies to the entire signal transmitter.
approx. 40 mm
In the extremities of the safety edge at approx. 60 mm (SE 40) or 50 mm (SE 70) finger guard is not guaranteed. Upon actuation of this area, the transmitter/receiver is pushed into the lower profile section and the switching signal is evaluated, but the required forces are high though. If this restriction is not acceptable for the specific application, constructive measures must be taken.
K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal The data and values have been checked throroughly. Technical modifications and errors excepted. Generiert am
14:14:16h Kasbase 3.3.0.F.64I