Notes Switch travel diagram Contact closed Contact open Setting range Break point Positive opening sequence/- angle VS adjustable range of NO contact VÖ adjustable range of NC contact N after travel
A safety edge system consists of individual components. The components must be ordered separately.
Example: Rubber profile, SE-P40-1250 Al profile, SE-AL 10-1250 Emitter/ Receiver SE-SET Safety-monitoring module, SE-304 C
Options: Caps SE-T40; Sticker SE-G8406 Other accessories
eCl@ss
27-27-34-01
Global Properties
Permanent light
Gummiprofil SE-P40
Standards
EN ISO 13850
Compliance with the Directives (Y/N)
No
Materials
- Material of the rubber profile
NBR perbunan®
Weight
880
Coated profile (Y/N)
No
Mechanical data
Mechanical life
20.000.000 operations
max. permanent load
500 on the operational switching zone
Response travel
max. 9 mm
After-travel
max. 18 mm
Ambient conditions
Protection class
IP67
notice
The protection class IP 67 applies to the entire signal transmitter.
Dimensions
Dimensions
- Width
25 mm
- Height
approx. 40 mm
- Length
2500 mm
notice
In the extremities of the safety edge at approx. 60 mm (SE 40) or 50 mm (SE 70) finger guard is not guaranteed. Upon actuation of this area, the transmitter/receiver is pushed into the lower profile section and the switching signal is evaluated, but the required forces are high though. If this restriction is not acceptable for the specific application, constructive measures must be taken.
K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal The data and values have been checked throroughly. Technical modifications and errors excepted. Generiert am
15.02.2019 -
04:00:48h Kasbase 3.3.0.F.64I