Notes Switch travel diagram
  Contact closed
  Contact open
  Setting range
  Break point
  Positive opening sequence/- angle
VS  adjustable range of NO contact
  adjustable range of NC contact
N   after travel
Deutsch  English  Francais  Nederlands  Italiano  Español  Português  Suomi  Svenska  Norsk  Dansk  Polska  日本語  Türkiye  中文  Português-br  
  
• Dirt and moisture in the profile are to a great extent compensated
• Insensitive to environmental conditions
• approx. 70 mm high

 
Preferred typ
 
Ordering details
 
Product type descriptionSE-P70-10000
Article number101172165
EAN Code4030661300221
A safety edge system consists of individual components.
The components must be ordered separately.
Example:
Rubber profile, SE-P70-1250
Al profile, SE-AL 20-1250
Emitter/ Receiver SE-SET
Safety-monitoring module, SE-304 C

Options:
Caps SE-T70; Sticker SE-G8406
Other accessories
eCl@ss27-27-34-01
 
Approval
 
Approval TÜV
UL
 
Global Properties
 
Permanent lightGummiprofil SE-P70
StandardsEN ISO 13850
Compliance with the Directives (Y/N) Yes
Materials
- Material of the rubber profileEPDM, 65 Shore A
Resistant to chemicals of the rubber material
- International abbreviationEPDM, 65 Shore A
- Chemical nameEthylene-propylene terpolymer
- Resilience at 20°CGood
- Resistance against permanent deformationGood
- General resistance against atmospheric conditionsExcellent
- Resistance against ozoneExcellent
- Resistance against oillow
- Resistance against fuellow
- Resistance against solventslow to satisfactory
- General resistance against acidsGood
Weight5925
Coated profile (Y/N)No
 
Mechanical data
 
Mechanical life20.000.000 operations
max. permanent load500 on the operational switching zone
Response travelmax. 9 mm
After-travelmax. 18 mm
 
Ambient conditions
 
Temperature resistance
- min. Temperature resistance−50 short duration
−30 long duration
- max. Temperature resistance+170 short duration
+140 long duration
Protection classIP67
noticeThe protection class IP 67 applies to the entire signal transmitter.
 
Dimensions
 
Dimensions
- Width25 mm
- Heightapprox. 70 mm
- Length10.000 mm
 
notice
 
If a higher resistance is required, choose safety edge profiles with 20 µm plastic coating. The coating must be submitted to low mechanical loads only.
In the extremities of the safety edge at approx. 60 mm (SE 40) or 50 mm (SE 70) finger guard is not guaranteed. Upon actuation of this area, the transmitter/receiver is pushed into the lower profile section and the switching signal is evaluated, but the required forces are high though.
If this restriction is not acceptable for the specific application, constructive measures must be taken.

K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal
The data and values have been checked throroughly. Technical modifications and errors excepted.
Generiert am 17.09.2019 - 15:01:35h Kasbase 3.3.0.F.64I