Notes Switch travel diagram Contact closed Contact open Setting range Break point Positive opening sequence/- angle VS adjustable range of NO contact VÖ adjustable range of NC contact N after travel
inductive interference protection, Protection against polarity reversal
Pressure resistant (Y/N)
No
Tightening torque for nuts
A/F 24 max. 1800 Ncm
• Wiring compartment
Ambient conditions
Ambient temperature
- Min. environmental temperature
−25
- Max. environmental temperature
+70
Protection class
IP65 to IEC/EN 60529
Electrical data
Design of control element
Normally open contact (NO) or Opener (NC)
Number of wire
3
Voltage type
DC, direct current
Supply voltage UB
- Min. supply voltage
10
- Max. supply voltage
60
Switch frequency
approx. 350 HZ
Voltage drop Ud
approx. 1.5 V (400 mA)
Operating current Ie
400 mA
No-load current I0
approx. 5.5 mA (24 V)
Outputs
Design of control output
PNP
LED switching conditions display
LED switching conditions display (Y/N)
Yes
- yellow LED
ATEX
Explosion protection categories for gases
None
Explosion protected category for dusts
None
Dimensions
Dimensions of the sensor
- Length of sensor
126
- Diameter of sensor
M18
notice
Instead of nuts, a mounting clamp can be provided.
Programmable by repositioning the plug-in jumper at the terminal screws
Diagram
Note Diagram positive break NC contact active no active Normally-open contact Normally-closed contact
Ordering suffix
The applicable ordering suffix is added at the end of the part number of the safety switch. Order example: IFL 8-18L-10/01P-1665-1
...-1665-1
short-circuit and overload proof Operating current Ie: 300 mA Voltage drop Ud: approx. 1 V (300 mA)
K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal The data and values have been checked throroughly. Technical modifications and errors excepted. Generiert am
20.02.2019 -
07:02:03h Kasbase 3.3.0.F.64I