Notes Switch travel diagram Contact closed Contact open Setting range Break point Positive opening sequence/- angle VS adjustable range of NO contact VÖ adjustable range of NC contact N after travel
• Metal enclosure • 184 mm x 111 mm x 149 mm (basic component) • 2 cable entries M 25 x 1.5 • 3 or 4 Contacts • Actuator heads can be repositioned by 4 x 90°
All indications about the cable section are including the conductor ferrules.
Design of actuating element
Offset roller lever
Contact opening
2 x 4
Actuating speed with vertical actuating angle to switch axis
- Min. Actuating speed
0,01 m/s
- Max. Actuating speed
1
- Actuating angle from left of switch axis
30
- Actuating angle from right of switch axis
45
Ambient conditions
Ambient temperature
- Min. environmental temperature
−30
- Max. environmental temperature
+90
Protection class
IP65 to IEC/EN 60529
Electrical data
Design of control element
Opener (NC)
- with double break
- galvanically separated contact bridges
Switching principle
Snap switch element
Number of shutters
0
Number of openers
4
Rated impulse withstand voltage Uimp
6 kV
Rated insulation voltage Ui
500 V
Thermal test current Ithe
25 A
Utilisation category
AC-15: 400 V / 25 A
Max. fuse rating
16 A gL/gG D-fuse
Dimensions
Dimensions of the sensor
- Width of sensor
- Height of sensor
90
- Length of sensor
149
Roller wide
9
Roller diameter
36
notice
notice
Actuation from the right should be avoided, since this reduces the mechanical life of the position switch.
Diagram
Note Diagram positive break NC contact active no active Normally-open contact Normally-closed contact
Ordering suffix
The applicable ordering suffix is added at the end of the part number of the safety switch. Order example: MJ 064-04Y-RMS
...-RMS
Available with metal roller
K.A. Schmersal GmbH & Co. KG, Möddinghofe 30, D-42279 Wuppertal The data and values have been checked throroughly. Technical modifications and errors excepted. Generiert am
18.02.2019 -
14:05:58h Kasbase 3.3.0.F.64I